Technical Data mt 6024gpi Specifications Genset engine 7.5 hp Briggs & Stratton generator type inductance nominal power generator 3000VA fuel bropane or butane gas duct magnetic valve - vaporizer - special carburetor Specifications Inverter nominal input voltage 24V output voltage 220V frequency 50Hz continuous power without genset 4000W continuous power with genset 6000W efficiency 94% peak maximum charger rate 100A charger type two stage, constant current forced air cooling brushless DC-fans DC Input Requirements search mode 0.04A (1W) full output voltage 0.42A (10W) nominal current 175A short circuited output 360A input voltage range 20 to 35V AC Output Characteristics following values are true also with genset in parallel and during charging wave form sine wave voltage control +/-2% step loads from 0 to 100% are regulated within 0.5ms total harmonic distortion smaller 2% frequency control 50Hz +/-0.04% Features control panel on/off-button and status LEDs for inverter and genset connectors remote control, handheld (PDA) with connector cable 50cm Adjustable Parameters (Examples) battery under voltage protection automatic genset start start, when battery low or large loads connected genset stop: end of charge, or current too high, fuel tank empty, etc. programmable single phase output relay10A programmable three phase output frequency converter 1.5kW Miscellaneous enclosure type indoor, ventilated, stainless steel chassis (IP 20) allowed temperature range -20 to 55°C dimensions inverter 275mm wide, 655mm high, 175mm deep dimensions genset mounting plate 480 x 390 mm, height over all 450 mm weight inverter 32kg weight genset 51kg standards (CE etc.) EN 61000-6-1, EN 61000-6-3, EN 55014, EN 55022, EN 61000-3-2, Dir. 89/336/EEC, LVD 73/23/EEC warranty 2 years Options enclosure genset (sound absorbing) cables remote control up to 20m length Bluetooth-connection between remote control and system class 1 (up to 1200m range) connection via POTS-modem or GSM-modem/cell phone ready to use modems three phase system